61 / 125
Notes on using the printer through the USB interface
(1) The printer must be connected directly to the host computer.
(2) Before starting printing, turn on the power to the printer.
(3) If a printer error occurs during printing, recover the printer from the error,
and then retry printing.
(4) The host computer should not be set to any of the following modes: standby,
sleep, suspend, and pause.
If the host computer or printer does not work normally after the host computer
returns to normal operation mode from one of the above modes, disconnect the
USB cable once and then reconnect it, or turn off the printer power switch once
and then turn on the switch again. If the host computer or printer cannot be
restored to normal operation after the cable is reconnected or power switch is
turned on again, restart the host computer.
(5) The USB hub function cannot be used when the power to the printer is off.
(6) If a peripheral device connected to the USB hub is not recognized, perform one
of the following operations:
- Disconnect the USB cable from the peripheral device once, and then reconnect
it.
- Connect the peripheral device to the other port of the USB hub.
(7) The operation of connected USB devices is not guaranteed. Before using a
USB device, verify its operation yourself.
Caution: Do not turn off the power to the printer during printing.
If you inadvertently turn off the power to the printer during
printing and the printer then fails to work normally, restart the
host computer.
Notes on using the printer through the serial interface
(1) When image data is printed with more than 100 transactions consequently via
OPOS driver setting serial printing, please stop printing for a while and start
again.
To Next Page
Loading...
Need help?
General