Importan t note s
FCC Class B Compliance Statement
The following statement a pplies to the products covered in this m anual, unless otherwise specified
herein. The statement for other products will appear in the accompanying documentation.
NOTE:
This equipment has been tested and found to comply with the limits for a "Class B" digital
device, pursuant to Part 15 of the FCC rules and meets all requirements of the Canadian
Interference-Causing Equipment Standard ICES-003 for digital apparatus. These limits are
designed to provide reasonable protection against harmful interference in a r esidential installation.
This equipment generates, uses and can radiate radio freque ncy energy and, if not installed
and used in strict accordance with the instructions, may cause harmful interference to radio
communications. However, there is no gu arantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on , the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relo cate the receiving antenna.
• Increase the separation between equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Fujitsu Technology Solutions GmbH is not responsible for any radio or television interference
caused by unauthorized modifications of this equipment or the s ubstitution or attach ment
of connecting cables and equipment other than those s pecified by Fujitsu Technology
Solutions GmbH. The correction of interferences caused by such unauthorized modification,
substitution or a ttachment will be the responsibility of the user.
The use of shielded I/O cables is required when connecting this equipment to any and all optional
peripheral or host devices. Failure to do so may violate FCC and ICES rules.
CE marking
The shipped version of this device c omplies with the requirements of EEC
directives 20 04/108/EC "Electromagnetic compatibility" and 2006/95/ EC
"Low voltage directive".
8 Fujitsu Technology Solutions
To Next Page
