Getting started
Connecting external devices
Read the d ocu m entation on the external device before connecting it.
With the exception of U SB devices, always remove all power plugs
before connecting external devices!
Do not connect or discon nect cables during a thunderstorm.
Always take hold of the actual plug. Never unplug a cable by pulling the cable itself.
Connect and disconnect the cables in the order described below.
Connecting the cables
► Turn off all power and equipment switches.
CordCable,
► Remove all po wer plugs from the grounded mains outlets.
► Connect all the cables to the device and the external devices. Please make sure that you
always observe the safety notes provided in "
Important notes", Page 6.
► Plug all data communication cables into the appropriate socke ts.
► Plug all power cables into the grounded mains outlets.
USB devices are hot-pluggable. This means you can connect and disconnect
USB cables while your device is switched on.
Additional information can be found in "
Connecting external devices to the USB
ports", Pag e 16 and in the documentation for the USB devices.
Disconnecting the cables
► Switch off all affected device s
.
Cable,
► Remove all po wer plugs from the grounded mains outlets.
► Unplug all data communication cabl
es from the appropriate sockets.
► Disconnect all of the cables from the device and from the external d evices.
Fujitsu Technology Solutions 13
To Next Page
