Using Your LifeBook E Series
LifeBook E Series from Fujitsu
57
when the Taskbar Icons are marked with a blue
and white bar. If you change your mind you
can continue by pressing the OK button.
8. You can now safely insert new devices into
both bays or one device into either bay with-
out damage to the computer or the device(s)
as long as you have not pressed the OK
button at this point.
9. Press the OK button after inserting the new
device to continue.
10. The software will automatically detect the
new devices and place them online.
Note: The software will always re-detect both
devices even if you only swapped one device or
you decided not to swap any devices at all.
11. All drive letters associated with both devices
will be re-created and listed under 'My
Computer' and 'Windows Explorer'.
12. The 'Taskbar Icons' and 'ToolTip Balloons'
will be updated to reflect the new devices
inserted in the bays.
Three
If you happen to press the OK button before
inserting a device into Multi-function Bay 1,
Tioman will display the following message:
No device detected in Bay 1.
Please insert a device before
clicking the Continue button.
You must insert a device into Multi-function
Bay 1 to continue at this point. If you choose
to cancel the warning message, Tioman will
prompt you to insert a device in Multi-function
Bay 1 the next time the 'Swap Devices'
command is run.
CAUTION
Make sure whenever you use Agate
Tiomon Hot-Swap software that you
always have at least one battery installed
in either Multi-function Bays of your
E Series notebook when you are running
on battery power alone. If you swap the
Primary Battery without having a
Secondary Battery installed in the other
Multi-function Bay, the system will lose
power once the Primary Battery is
removed when you are running on battery
power alone. It is always safe to hot-swap
your E Series Bay Devices when you are
powering the system with the AC adapter.
CAUTION
You should never leave your Multi-func-
tion Bays empty when the notebook is in
operation. The Weight Saver is intended
to occupy Multi-function Bay 2 when no
other device is needed.
To Next Page
Loading...
