Fujitsu LIFEBOOK E554 - System Recovery Options

Appendix
Determining whether Recovery and Utility is pre-loaded
1. Turn on or reboot your system. When the F ujitsu logo appears, press the
F12
key.
2. Use the
Tab
key to get to the Application Menu.
3. Check whether the Recovery and Utility option is present. If it is not present, it mean s
that the utility must be used from the Bootable Disk. Proceed to “Running Recovery and
Utility from the Bootable Disk” if Recovery and Utility is unavailable.
Running Recovery and Utility from hard disk
1. Turn on or reboot your system. When the F ujitsu logo appears, press the
F12
key.
2. Use the
Tab
key to get to the Application Menu.
3. Cursor down to Recovery and Utility and press the
Enter
key.
4. Choose y our language, if necessary. Select Recovery and Utility to proceed.
5. Three tool options appear: Diagnostics, Recovery,andUtility (refer to the Recovery and
Utility tools section below for instructions on how to use t hese tools).
6. If this was su ccessful please skip the next step and go to “Recovery and Utility tools.”
7. If this was NOT su ccessful, please go to the next step .
Running Recovery and U tility from the Bootable disk
To verify/change the boot-up priority (rather than booting-up from the hard drive or
an external media drive), perform the following steps:
1. Power on y our system. When the Fujitsu logo ap pears on the screen, press the
F12
key.
2. Insert the bootab le disk into the drive tray.
3. Highlight the CD/DVD option from the Boot menu, then press
Enter
.
4. Click OK.
5. Select CD/DVD boot mode: UEFI Mode, if applicable, and then press
Enter
.
While the files are being loade d fro m the disk, the Fujitsu logo screen will appear
followed by a progress bar at the bottom of the screen.
96 Fujitsu