Working with the notebook
Connecting the AC adapter to the Port Replicator
3
1
2
► Connect the power cable to the
AC adapter (1).
► Plug the power cable into the powe r
outlet (2).
► Connect the AC adapter ca ble to the DC
jack (DC IN) o f the P ort Replicator (3).
Power Outlets will vary from country to country, see chapter "When
travel ling in other countries ", Page 16.
When the notebook is connected to a Port Replicator, the operating system creates
a hardware profile for the "Docked" mode. In this profile, for example, the setting is
saved as to which monitor was last used for output. This profile will be loaded, as
soon as the notebook is connected to a Port Replicator of the same type.
Switching on the notebook via the port replicator
► Press the Power O N/O FF button on the p ort
replicator to switch the notebook on.
The power-on indicator of the P ort
Replicator lights up.
Fujitsu 51
To Next Page
Loading...
