Troubleshooting and tips
The radio connection to a networ
k does not work
Theradioc onnectiont oanetwo rkdoesnot work
(Possible) Cause Troubleshoo ting
The wireless compo nent is disa
bled.
► Switch the radio component on (see
"
Switch ing t he wireless component s on and
off", Page 45).
The wireless component is enabled. Despite
this, the wireless connection to a network does
not work.
► Check whether the radio connection is
switched on via the software.
► Furt her information on using the radio
component can be found in the help files.
Acoustic warnings
Acousticerror messagesErrors
Cause
Troubleshooting
A beep sounds every few seconds.
The battery is almost flat.
► Charge the b attery.
SmartCard reader is not recognized
Cause
Troubleshooting
Chip card inserted inc o rrectly.
► M ake sure you have inserted your
SmartCard into the SmartCard reader with
the chip facing upwards.
► Check whether the SmartCard you a re using
is supported. Your SmartCard must comply
with the ISO standard 7816-1, -2, -3 and -4.
SmartCard PIN forgotten
Cause
Troubleshooting
PIN forgotten ► If you are working in a network, con tact your
system administrator, who can unlock your
notebook with a Supervisor PIN.
SmartCard lost
Cause
Troubleshooting
SmartCa
rd lost
► If you ar
e wo rking in a ne twork, contact yo ur
system a
dministrator, who can boot up your
notebo
ok with a Supervisor Sma rtCa rd.
Fujitsu 79
To Next Page
Loading...
