Fujitsu LIFEBOOK E744 - Technical Data

Troubleshooting and tips
Error messages on the screen
Errormess agesonthe screenError message:
This section describes the e rro r messages generated by the BIOS Setup. Error messages displayed
by the operating system or programs are described in the relevant docum entation.
If the error message appea rs repeatedly, despite troubleshooting measure s, please
contact the place of purchase or our customer service centre.
Error m essag e/cause Resolution
CMOS battery bad
If the error message occurs repeatedly, the
buffer battery in the notebook is flat.
► Contact your sales outlet
or our customer
service centre.
System CMOS checksum bad - default configuration
used
The system configuration inform ation is
incorrect.
► Switch the notebook of
f.
► Switch the notebook on.
► Press the function k
ey
F2
to access the
BIOS Se tup.
► In the BIO S Setup, select the Exit menu.
► Select the entry Lo
ad Setup Defaults.
► Select OK and press the En ter key.
Extended memory failed at offset: xxxx Failing Bits:
zzzz zzzz
When testing the extende d memory an error has
resulted at the address xxxx.
► Check whether the additional memory
module has been inserted correctly.
Failure Fixed Disk n
The settings of the hard disk drive are incorrect.
► Start the BIOS Setup (P ri mary Master
submenu) and select the correct settings.
Keyboard controller error
► Switch the noteboo k o ff with the Power
ON/OFF button.
► Wait 3 - 5 seconds and switch on the
notebook again.
Keyboard error
If you are using an external keyboard:
► Check the connection and reboot the
notebook.
nn Stuck key
► Make sure that no key is pressed.
Operating system not found
► Check
in the B IOS Setup whether your hard
disk h
as been set correctly.
► Make sure th at the operating system is
installed on the corresponding drive.
Press <F1> to resume, < F2> to SETUP
This error message appears if an error occurs
during the se lf-test before starting the operating
system.
► Press the
F1
function key to s tart the
operating system.
► Press the function key
F2
to access the
BIOS Se tup.
80 Fujitsu