Security functions
Using Security Panel
Entering security password
During the next reboot a key symbol
in the display field indicates that Security Panel is
activated. Your notebook does not start up until you have correctly entered your selected user
password.
For the example in the section "Setting a supervisor password" (2/3 4 1/3/4 2 1/2/3/4), the
following steps are necessary:
► Simultaneously press the security keys 2 and 3.
► Press the security button 4.
► Simultaneously press the security keys 1, 3 and 4.
► Press the security button 2.
► Simultaneously press the security keys 1, 2, 3 and 4.
► Then press the Enter key to complete the entry.
Your notebook boots.
The Security Panel is never activated with the functions
Wake on Ring, Wake on LAN and
Time Resume. This means the notebook boots without password entry with the functions
named.
i
Password error alarm
If the password is entered incorrectly three times, a one-minute alarm is triggered. If the correct
password is still entered during the alarm, the notebook boots as usual.
After one minute the notebook stops the alarm. The user must press the Suspend/Resume key. The
key symbol
appears in the display field - the user must now enter the correct user password.
Upon correct entry the notebook boots.
Changing or removing security password
After you have installed the programs FJSECS.EXE and FJSECU.EXE, you will find the entry Security
control
under Start - Programs. Here you can change or completely remove your user password. In
this case follow the instructions of the programme.
56 A26391-K164-Z120-1-7619, edition 2
To Next Page
Loading...
