Removing and installing components
during servicing
Installing and removing an M.2 m
odule
Removing a cover
► To prepare to remove this m odule, see "Preparing to remove components", Page 78.
1
2
► Remove the screw (1).
Keep the screw in a sensible place where you’ll be sure to find it. If you want
to remove several compo nents at the same time, keep the screws for these
individual com ponents separate from each oth er. If you insert the wrong screw
into a c ompone nt, you might damage the component.
The screws do not all have the same length, and the correct screw
must be used when fitting the cover.
► Lift the cover off the notebook (2).
82 Fujitsu
To Next Page
Loading...
