Working w ith the notebook
Setting up t he dock
Choose a suitable lo cation for the dock before setting it up. In doing
so, please follow these instructions:
• Never place the dock on a soft surface (e.g. carpeting, upholstered furniture, bed). This
can block the air vents of the notebook and cause overheating and damage.
• Place the dock on a stable, flat, non-slippery surface. Please note that the rubber
feet of th e dock m ay mark certain types of delicate surfaces.
• Never place the dock or the AC adapter on a heat-sensitive surf ace.
• Do not expose the dock to extreme environmental conditions.
Protect the dock against dust, humidity and heat .
Connect the AC adapter to the dock
3
1
2
► Connect the power line (1) to the network
adapter provided for use with the device,
see chapter "
Technical data", Page 88.
► Plug the AC cable into the power outlet (2).
► Connect the AC adapter cable to the DC
jack (DC IN) of the dock (3).
When the notebook is connected to a dock, the operating system creates a
hardware profile for the "Docked" mode. In this profile, for example, the m onitor
which was last used for output is save d as a setting. This profile will be loaded
as soon as the notebook is connected to a dock of the same type.
58 Fujitsu
To Next Page
Loading...
