Security functions
Password protection for booting the operatin g system
With the supervisor password you have set in the BIOS Se tup Utility (see
section "
Assigning the supervisor and user password s", Page 66), you can
also prevent booting of the operating system.
Operating system
Activating system protection
► Start the BIOS Setup Utility and go to the Security menu.
Operatingsystem
► Select the PasswordonBootoption and press the Enter key.
► Select the option you require (Disabled, First Boot or Every Boot) and press the enter key
► Select the Save Changes & Exit opt ion under Exit.
The n otebook will reboot. You will be prompted to enter your password (the s upervisor password).
Deactivating system protection
► Start the BIOS Setup Utility and go to the Security menu.
Operatingsystem
► Select the PasswordonBootoption and press the Enter key.
► Select the Disabled option and press the Enter key.
If you d o not want to change any other settings, you can exit BIOS Setup Utility.
► Select the Save Changes & Exit opt ion under Exit.
The notebook will reboot. The system is no longer password-protected.
Password protection for the hard disk
If a supervisor pa ssword was set, an additional password for the hard disk
canbesetintheHard Disk Security menu.
The hard disk is protected by this password. Data on this hard disk can then only be
read in anoth er system if the correct password is entered.
Fujitsu 67
To Next Page
Loading...
