Security functions
Assigning the supervisor and user passwords
► Start the B IOS Setup Utility and go to the Security menu.
► Select the Set Supervisor Password fie ld and press the Enter key.
With Enter new Password: you are asked to enter a password.
► Enter the password and press the Enter key.
Confirm ne w Password requires you to confirm the passw ord.
► Enter the pa ssword again and press the Enter key.
Changes have been saved is displayed as a con firmation that the new password has been saved.
► To set the user password, select Set User Password and proceed exactly as
when configuring the supervisor password.
If you d o not want to change any other settings, you can exit BIOS Setup Utility.
► In the Exit menu, select the option Save Changes & Exit.
► Select Yes and press the Enter key.
PasswordSupervisorpasswor
d
Userpassword
The no tebook is then rebooted and the new password c omes into effect. It will now be necessary
to first enter your supervisor or user password in order to open the BIOS Setup Utility.Please
note that the user password only provides access to a few of the BIO S settings.
Changing the supervisor password or user password
You can only change the supervisor password when you have logg ed into the
BIOS Setup Utility with the s upervisor p assword.
PasswordSupervisorpasswordUserpassword
► Start the B IOS Setup Utility and go to the Security menu.
► When changing the password, proceed exactly as when assigning a password.
Removing passwords
To remove a password ( without setting a new passwo rd) perform the following steps:
PasswordSupervisor
password
Userpasswo
rd
► Start the B IOS Setup Utility and go to the Security menu.
► Highlight the Set Supervisor Password or Set User Password field and press the Enter k ey.
You will be requested to enter the c urrent password by the Enter Current Password prompt.
Enter New Password will appea r and you will be requeste d to enter a new password.
► Press the Enter key twice at this request.
► In the Exit menu, select the option Save Changes & Exit.
► Select Yes and press the Enter key.
The notebo ok will now reboot with the password removed.
With the supervisor password, you simultaneously deactivate the user password.
66 Fujitsu
To Next Page
Loading...
