6.1 Using ScanSnap Manager
ScanSnap S510 Operator's Guide 183
Using the ScanSnap in Various Ways
6
6. Load the document onto the paper chute.
ATTENTION
• Place all documents in the center under the pick roller.
(Documents that are not under the pick roller cannot be fed.)
• Adjust the side guides to the widest document.
• Carefully load the smaller documents, which cannot contact the side guide, so
that they can be fed straight. If the documents are skewed during a scan, the
quality of scanned images may be degraded (chipped images/slant lines
produced) or scanned images may be output in different size from the original.
If you have difficulties feeding documents straight, it is recommended to scan
documents in several batches; scan documents of about the same width in
one batch.
Note that smaller documents that cannot be guided by the side guide may
cause a jam.
SCAN
POWER
SCAN
POWER
Width of the pick roller
To Next Page
Loading...
Need help?
General