Fujitsu plasmavision - Basic Operations

E-12
BASIC OPERATIONS
TURNING THE POWER ON AND STAND-BY
1
Press/I to the left at the bottom of
the display to the ON
state.
The power lamp lights up.
2
Press  on the remote control.
The color of the power lamp changes from “Red” to
“Green”.
3
Press " – & or ) – *.
Select the video mode to input.
4
Press  when the power is ON.
The color of the power lamp changes from “Green”
to “Red” and the the power turns “OFF (Stand-by
state)”.
* You can also use the buttons
on the display’s control
panel to perform these steps.
(for the W/R models)
* You can also use the buttons
on the display’s control
panel to perform these steps.
(for the U model)
MHD01661-02_E.book 12 ページ ２００４年１２月２２日 水曜日 午後５時１５分