Fujitsu plasmavision User Manual

E-14
SELECTING INPUT MODE
VIDEO INPUT MODE (for the W/R models)
1
Press "-= to select the input
mode.
You can select from VIDEO1 mode to VIDEO4
mode.
The video modes corresponding to each input
terminal are as follows.
•VIDEO1: Video
• VIDEO2: S-video
• VIDEO3: Component video
• VIDEO4: Component video
* For selection of the input terminal, see
“SETTING THE INPUT TERMINALS” on
P. E- 3 1.
VIDEO INPUT MODE (for the U model)
1
Press "-& to select the input
mode.
You can select from VIDEO1 mode to VIDEO5
mode.
The video modes corresponding to each input
terminal are as follows.
•VIDEO1: Video
• VIDEO2: S-video
• VIDEO3: Component video
• VIDEO4: Component video
• VIDEO5: HDMI
* For selection of the input terminal, see
“SETTING THE INPUT TERMINALS” on
P. E- 3 1.
* You can also use the buttons
on the display’s control
panel to perform these steps.
Video1 mode
* You can also use the buttons
on the display’s control
panel to perform these steps.
Video1 mode
MHD01661-02_E.book 14 ページ ２００４年１２月２２日 水曜日 午後５時１５分

Fujitsu plasmavision Specifications

General

Brand	Fujitsu
Model	plasmavision
Category	Monitor
Language	English