Fujitsu PRIMERGY LTO3 - Setting Jumpers

60
1.2 Setting Jumpers
Normally it is not necessary to change the SCSI-ID.
The SCSI-ID can be set using the short jumpers on the rear of the unit (diagram below).
The SCSI-ID can be set as shown in the following table.
SCSI-ID
Short jumper
3 2 1 0
0 OpenOpenOpenOpen
1 Open Open Open Short
2 Open Open Short Open
3 Open Open Short Short
4 Open Short Open Open
5 (*) Open Short Open Short
6 Open Short Short Open
7 Short Short Short Short
8 Short Open Open Open
9 Short Open Open Short
10 Short Open Short Open
11 Short Open Short Short
12 Short Short Open Open
13 Short Short Open Short
14 Short Short Short Open
15 Short Short Short Short
*: Settings at the time of purchase
SCSI connector Power connector
SCSI-ID 0
SCSI-ID 1
SCSI-ID 2
SCSI-ID 3
Reserved
Te r m Po w e r
Short jumpers
[Rear]