Fujitsu PRIMERGY LTO3 - Installation Environment Checklist; Other Operation Checklist

Appendix A Operation Check Sheet(Installation/Operation Check) 87
E
Installation
environment
8
❑
Is the environment
of this product (the
server if it is built in
the server) dust-
free?
This product is susceptible to its installation
environment (especially dust) because the data-
recording surface is exposed inside the device. The
closer to the floor, the higher the dust level is in general,
so it is recommended to install this product away from
the floor, such as on a desk.
* Install this product in less dusty environments,
referring to the [Examples of installation
environments to avoid].
[Examples of installation environments to avoid]
• On the floor.
• High-traffic areas
• Areas close to open doors/windows, Especially,
where affected by the external environment, such as
sandy dust, car exhaust emissions, etc.
• Areas close to air ventilating ducts. (be careful of air
conditioners, exhaust fans, etc.)
• Areas affected by cigarette smoke (Do not smoke in
the room where this product is installed)
• Areas close to printers and affected by a toner
• Areas close to paper-handling devices, such as copy
machines, shredders, or fax machines, that are
affected by paper particles.
Reconsider the installation location if dust accumulates
at the tape slot and around the product within a few
months of installation.
Others
9
❑
When this product
(the server if it is
built in the server) is
turned off or
restarted, is the data
cartridge ejected?
Generally, the data cartridge may write the tape
management data only when the tape (the data cartridge
for LTO) is ejected. Therefore, if the power of the tape
device is turned off while the tape is inside, a faulty tape
where no management data can be written will be
created and problems such as data restore failure will
occur.
* Before turning off the data cartridge (the server), eject
the tape (the data cartridge for LTO).
10
❑
Are two or more
data cartridges used
for backup and
generation
management? (Is a
different data
cartridge used every
time?)
When using a single tape (data cartridge for LTO) over
and over for backup, important backup data can be lost
temporarily in the event the backup fails.
* Use two or more data cartridges for backup and
perform generation management.
Classificat
ion
No Check Check item Description / tasks (*)