Fujitsu PRIMERGY - Page 41

11
E
AdvancedConfigurationOptions Defaultsetting
ResetSCSIBusatICInitialization Enabled
HostAdapterBIOS(ConfigurationUtilityReserves Enabled
BIOSSpace)
SupportRemovableDisksUnderBIOSasFixedDisks*
2
Bootonly
ExtendedBIOSTranslationforDOSDrivers>1Gbyte*
2
Enabled
Display<Ctrl-A>MessageDuringBIOSInitialization*
2
Enabled
MultipleLUNSupport*
2
Disabled
BIOSSupportforBootableCD-ROM*
2
Disabled
BIOSSupportforInt13Extensions*
2
Enabled
SupportforUltraSCSISpeed*
3
Enabled
*2 Tobe"Enabled"onlywhenthe"HostAdapterBIOS"issetto｢Enabled｣.
*3 Whenthe"SupportforUltraSCSISpeed"issetto｢Enabled｣andthe"InitiateWideNegotiation"issetto｢yes｣,thesetting
valueofthe"MaximumSyncTransferRate"is40MB/s.
■ Explanationofeachsetting
1SCSIBusInterfaceDefinitions
・ HostAdapterSCSIID
SelectingthisoptionallowsyoutosettheSCSIIDofthiscard.Thedefault
settingisSCSIID=7.ThiscardhasthehighestpriorityontheSCSIbus.We
recommendthatyouleavethiscardIDsetto7.
・ SCSIParityChecking
Selectingthisoptionallowsyoutodeterminewhetherdataistransferred
accuratelyontheSCSIbusorwhetherthiscardcheckstheparity.Thedefault
settingis｢Enabled｣.IfanySCSIdevicebeingconnectedtothiscarddoesnot
supporttheSCSIparityfunction,｢Disabled｣theSCSIParityChecking
function.MostSCSIdevicessupportSCSIparity.Ifyoudonotknow
whethertheSCSIdevicesupportsSCSIparity,refertothatSCSIdevice's
documentation.
・ HostAdapterSCSITermination
ThisoptionallowsyoutoconfigureSCSIterminationusingthiscard.This
carddefaultsettingis｢Automatic｣.Werecommendthatyouleavethiscard
setitsdefaultsettingof｢Automatic｣.
Note
TheSCSIterminatorsofthiscardarealwaysactivatedbecausethe
jumpersJ2andJ4ofthiscardareshort-circuited.