Fujitsu PRIMERGY - Page 47

17
E
・ BIOSSupportforBootableCD-ROM
ThisoptionallowsyoutodeterminewhetherHostAdapterBIOSsupports
bootingfromaCD-ROMdrive.Thedefaultsettingis｢Disabled｣.
・ BIOSSupportforInt13Extensions
ThisoptionallowsyoutodeterminewhetherHostAdapterBIOSsupportsa
diskwithmorethan1024cylinders.Thedefaultsettingis｢Enabled｣.
・ SupportforUltraSCSISpeed
ThisoptionallowstheSCSIcardtosupportUltraWideSCSIspeeds(transfer
ratesof20.0,26.8,32.0,and40.0MB/s).(InthecaseanUltraWideSCSI
deviceisconnected.)Thedefaultsettingis｢Enabled｣.
(2) SCSIDiskUtilities
■ UsingtheSCSIDiskUtilities
ToaccessaSCSIdiskutility,selecttheSCSIDiskUtilitiesoptionfromthemenuthat
appearsafterSCSISelectUtilityisstarted.(Refertothechapter"3.2Activatingand
terminatingtheSCSISelectUtility".)Whentheoptionisselected,SCSISelectUtility
immediatelyscanstheSCSIbusanddisplaysalistofallSCSIIDsandthedevice
assignedtoeachID.
WhenyouselectaspecificIDanddevice,asmallmenuappears,displayingthe
optionsFormatDiskandVerifyDiskMedia.
・ FormatDisk
Thisutilityallowsyoutoperformalow-levelformatonaharddiskdrive.
MostSCSIdiskdevicesarepreformattedatthefactoryanddonotneedtobe
reformatted.
Note
Ifyouperformalow-levelformat,alldrivedataisdestroyed.Backupdata
beforeperformingthisoperation.Oncealow-levelformatstarts,itcannot
bestoppedpartway.
・ VerifyDiskMedia
Thisutilityallowsyoutoscantheharddiskfordefects.Iftheutilityfindsbad
blocks,itpromptsyoutoreassignthem.Ifyouselect｢yes｣,thoseblocksare
nolongerused.Youcanpressthe[ESC]keyatanytimetoaborttheutility.