Fujitsu SP-1125N User Manual

ATTENTION
Ways to designate the scanning area differ depending on the image scanning application or the scanner
driver. For details, refer to the manual for the image scanning application or the help for the scanner driver.
If paper jams occur frequently, take measures according to Paper Jams/Pick Errors Occur Frequently (page 112).
If the problem still persists, write down the status of the indicators, check each item in Before You Contact the
Scanner Service Provider (page 117) and then contact the distributor/dealer where you purchased this product.
Refer to the contact information in the Contact List if supplied with this product, or refer to the contact
information in the Contact for Inquiries section if provided in Safety Precautions supplied with this product, and
then make an inquiry.
Multifeed
If a multifeed occurs, the indicators on the operator panel light up as follows.
Check Indicator Power Indicator
On On
When you press the scan/stop button on the operator panel, the overlapped documents are ejected.
If documents remain in the scanner, remove the documents by referring to When a Paper Jam Occurs (page
87).
If documents are overlapped and fed into the scanner frequently, take measures according to Overlapped
Documents Are Frequently Fed into the Scanner (page 109).
If the problem still persists, write down the status of the indicators, check each item in Before You Contact the
Scanner Service Provider (page 117) and then contact the distributor/dealer where you purchased this product.
Refer to the contact information in the Contact List if supplied with this product, or refer to the contact
information in the Contact for Inquiries section if provided in Safety Precautions supplied with this product, and
then make an inquiry.
Cover Open
If you open the ADF during a scan, the indicators on the operator panel light up as follows.
Check Indicator Power Indicator
On On
HINT
Note that operations on the operator panel are disabled while the ADF is open.
Remove the document from the ADF, and close the ADF.
Confirm that the ADF is closed properly.
To check whether or not it is closed completely, open the ADF and then close it again.
For more details about opening and closing the ADF, refer to Opening/Closing the ADF (page 34).
Troubleshooting
92

Fujitsu SP-1125N Specifications

General

Color scanning	Yes
Maximum scan size	210 x 297 mm
Output color depth	24 bit
Output grayscale depth	8 bit
Output monochrome depth	1 bit
ADF scan speed (b/w, A4)	25 ppm
Optical scanning resolution	600 x 600 DPI
Scanner type	ADF scanner
Product color	Gray
Built-in display	No
Sensor type	CMOS dual CIS
Scan drivers	ISIS, TWAIN
Scan file formats	PDF
Daily duty cycle (max)	- pages
Maximum ISO A-series paper size	A4
USB version	3.2 Gen 1 (3.1 Gen 1)
Input voltage	100 - 240 V
Power supply type	AC
Power consumption (off)	0.3 W
Power consumption (sleep)	2 W
Power consumption (typical)	18 W
Operating temperature (T-T)	5 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Sustainability certificates	ENERGY STAR
Harmonized System (HS) code	84716070

Weight and Dimensions

Depth	135 mm
Width	298 mm
Height	133 mm
Weight	2500 g