The LEDs turn on or blink to indicate the statuses that are listed below.
Table 1.1 Status and Meanings of Each LED (Operation Panel (Controller Enclosure))
LED name LED status Meanings
POWER
(green)
Power is supplied to the controller enclosure.
IDENTIFY
(blinks blue)
The installation location of the controller enclosure is identified
according to the instruction that is issued from ETERNUS Web GUI
or ETERNUS CLI.
FAULT
(amber)
The ETERNUS AF is in error status.
(blinks amber)
A part of the ETERNUS AF requires preventive maintenance.
MAINTENANCE
(green)
Maintenance for the ETERNUS AF is in progress.
(blinks green)
Maintenance (from ETERNUS Web GUI or ETERNUS CLI) for the
ETERNUS AF is in progress or a status check of the ETERNUS AF
is
necessary.
CACHE
(green)
There is data in the cache memory of the ETERNUS AF.
READY
(green)
The ETERNUS AF is available for use.
REMOTE
(green)
The ETERNUS AF is turned on and off with the server.
■
Batteries
Batteries are used for backup power source in case of power outage.
Batteries have LEDs.
Figure 1.5 shows the battery. Table 1.2 shows the status and meanings of each LED.
Figure 1.5 Battery
1. BRDY LED
2. CHG LED
3. BCA LED
4. BTA LED
The states of LEDs are listed below.
Table 1.2 Status and Meanings of Each LED (Battery)
LED name LED status Meaning
BRDY
(Battery Ready)
(green)
The battery charge rate is 90% or more.
CHG
(Charge)
(green)
The battery is being charged or is ready for discharge.
Chapter 1 Component Names and LED Names
1.1 Controller Enclosures
15
FUJITSU Storage ETERNUS AF650 S2, ETERNUS AF650 All-Flash Arrays
Operation Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AG-1932-04ENZ0
To Next Page
Loading...
