Fujitsu Storage ETERNUS AF650 S2 - Figure 1.8 Host Interface for FC Cable Connections (4 Port)

■
Host Interfaces
A host interface is a board that has interface ports to connect a controller to the server.
Figure 1.8 and Figure 1.9 show host interfaces. Table 1.4
shows the status and meanings of each LED.
● Host Interface (for FC Cable Connections) (4port)
The ports on the host interface are used for connecting a controller to a server with an FC cable. There is one
type of 4port host interface for FC cable connections: FC 16Gbit/s.
Figure 1.8 Host Interface for FC cable connections (4port)
12 3
4 5 6 7
1. CA READY LED
2. CA FAULT LED
3. LINK/FAULT LED
4. Host Interface Port #0
5. Host Interface Port #1
6. Host Interface Port #2
7. Host Interface Port #3
● Host Interface
(for FC Cable Connections) (2port)
The ports on the host interface are used for connecting a controller to a server with an FC cable. There are
three types of 2port host interfaces for FC cable connections: FC 32Gbit/s, FC 16Gbit/s, and iSCSI 10Gbit/s.
The following figure shows an example of when the host interface is FC.
Figure 1.9 Host Interface for FC Cable Connections (2port, Equipped with SFP+ Modules in All Ports)
4 5
12 3
1. CA READY LED
2. CA FAULT LED
3. LINK/FAULT LED
4. Host Interface Port #0
5. Host Interface Port #1
Chapter 1 Component Names and LED Names
1.1 Controller Enclosures
18
FUJITSU Storage ETERNUS AF650 S2, ETERNUS AF650 All-Flash Arrays
Operation Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AG-1932-04ENZ0