1 Press and hold the Power switch of the controller enclosure for four seconds or more.
Controller enclosure
Power switch
The READY LED on the controller enclosure is turned off.
Press the Power switch only once. If the Power switch is pressed again between the time of the
READY LED turning off and the POWER LED turning off, the
ETERNUS AF power may turn on.
2 The power of the ETERNUS AF
is disconnected.
When the power is disconnected, the POWER LED of the controller enclosure and the POWER LEDs of the
drive enclosures are turned off.
Chapter 2 Basic Operation
2.2 Powering On and Off
39
FUJITSU Storage ETERNUS AF650 S2, ETERNUS AF650 All-Flash Arrays
Operation Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AG-1932-04ENZ0
To Next Page
Loading...
