Troubleshooting and tips
Acoustic warning
Acou stic war ningsErrors
Cause
Troubleshooting
A beep sounds every few secon ds.
The battery is almost flat.
► Ch arge the battery.
Error messages on the screen
Errormess agesonthe sc
reen
Errors
This section describes the e rro r messages generated by the BIOS Setup. Error messages displayed
by the opera ting system or programs are d escri bed in the d ocu m entation for these prog rams.
If the error message appears repeatedly despite troubleshooting measures,
contact th e place of purchase or our customer service center.
Error m essag e/cau se Troubleshooting
CMOS Battery Bad
If the error message occurs repeatedly, the
buffer battery in the Tablet PC is flat.
► Contact your sales outlet or our customer
service center.
System CMOS checksum bad - Default configuration
used
The system configuration inform ation is
incorrect.
► Switch the Tablet PC off.
► Switch the Tablet PC on.
► Keep the volume button and the shortcut
button pressed and switch the Tablet P C
on. If you keep the volume button pressed
during the boot process, you can sw itch into
the BIOS Setup-
► In the BIOS Setup, select the Exit menu.
► Select the entry Load Se tup Defaults.
► Select OK and press the Enter key.
Extended memory failed at offset: xxxx Failing Bits:
zzzz zzzz
When testing the extended memory. an error
has resulted at the address xxxx.
► Contact you
r sales outlet o r our customer
service c en
ter.
Failure Fixed Disk n
The settings of the hard disk drive are incorrect.
► Start the
BIOS Setup (Primary M aster
submenu
) and select the correct settings.
Keyboard controller error
► Switch
your Tablet PC off with the ON/OFF
butto
n.
► Wait 3 - 5 seconds and switch the Tablet PC
on again.
Keyboard error
If you use an external ke yboard:
► Check the co nnection and reboot the Tablet
PC.
nn Stuck key
► Make sure that no key is pressed.
76 Fujitsu
To Next Page
Loading...
Need help?
General