Manufacturer’s notes
For A u th orized Repair Techni cians Only
CAUTION:
For continued protection against r isk of fire, replace only with the
same type a nd rating fuse.
WARNING:
Danger of exp losion if Lit
hium (CMOS) battery is incorrectly replaced. Replace only
with the same or equivalen
t type recommended by the manufacturer.
Dispose of used batterie
s according to the manufacturer’s instructions.
FCC Regulatory information
Regulatoryinformation
Federal Communic atio ns Comm issio n statement
This device complies with Part 15 of FCC Rules. Operation is subject to the following
two co nditions: (1) this device may not ca use interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of this d evice.
FCC Interference Statement
This equipment has bee n tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy. If not installed and used in accordance with
the instructions, it may cause harmful interference to radio communications.
However, there is no guarantee that interference w ill not occur in a particular insta llation.
If this equipment does cause harmful interference to radio or television r ece ption, w hich
can be determined by turning the equipment off and on, the user is encouraged to try to
correct t he interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the dista nce between the equipment and the receiver.
3. Connect the equipment to an outlet on a circu it different from the one the receiver is connected to.
4. Consult the dealer or an experienced radio/TV technician for help.
Please note the fo llowing regulatory information related to the optional radio device.
FCC Radio Frequency Exposure statement
This radio device has been evaluated u nder FCC Bulletin OET 65C an d found compliant with the
requirements as set forth in CFR 47 Sections 2.1091, 2.1093, and 15.24 7 (b) (4) addressing RF
Exposure from radio frequency devices. The radiated output power of this radio device is far below
the FCC radio frequency exposure limits. Nevertheless, this device s hall be used in such a manner
that the potential for human contact during normal operation is minimized. When using this device, a
certain separation distance between antenna and nearby persons must be maintained to ensure R F
exposure compliance. In order to comply with RF exposure limits established in the ANSI C95.1
standards, the distance between the antennas and the user should not be less than 20 cm (8 inches).
Regulatory Notes and Statements
Radio device, health and authorization for use
Fujitsu 85
To Next Page
Loading...
