Fujitsu STYLISTIC Q584 - Appendix: System Backup and Recovery; Image Backup and Recovery Procedures; Creating Recovery Disk Sets

Appendix
Auto-installation support for essential access software
from backup location
The below listed steps are ap plicable in cases in which a backup copy was created as
mentioned in the section “Creating a Backup of essential access software”.
1. It is important to have the extracted Auto installer software packag e folder
and Readme file in the same location as other software folders. Otherwise
auto-installation of the software will not be supported.
2. Inside the Auto Installer softw are packag e , launch FjAuto install.exe as an Administrator.
3. Click Yes on the User Acco unt Control d ialog box. This will take some time to
process the software packages. A message will be displayed during this time stating,
“Please wait while the content is being processed”.
4. If EULA is displayed for Fujitsu Software Auto Installer, accept the EULA, otherwise continue.
5. The Fujitsu Software Auto Installer user interface will be launched providing ability
to auto install th e essential access s oftware on the system.
6. It is recommended that you install all the software in th e listed orde r. You can
“Select All”, to install the software in the order listed.
7. Click the Install button to start the installation.
8. After installing all the selecte d drivers, Installa tio n Results window is be displayed. Click OK.
9. “You must restart the system for the settings to take effect. Do you wish to
reboot now?” message appears. Select Yes.
10. The system will now reboot.
Auto Installation support for the software downloaded from support website
1. Download FSDM (Fujitsu Software Download Manager) from the support site and download all
the d rivers applicable to the model and OS using FSDM if they are not downloaded yet.
2. When the software packages are dow nloaded from we b, it is important to download
the A u to Installer Software package a nd the model/languag e- speci fic Readme
file if you prefer to auto install the software.
3. It is important to have the extracted Auto Installer software package fo lder
and Readme file in the same location as other software folders. Otherwise
auto-installation of the software will not be supported.
4. Inside the Aut o Installer software package, launch FjAutoinstall.exe as administrator.
5. Click Yes on the User Acco unt Control d ialog box. This will take some time to
process the software packages. A message will be displayed during this time stating
“Please wait while the content is being processed”.
6. If EULA is displayed for Fujitsu Software Auto Installer, accept the EULA, otherwise continue.
7. The Fujitsu Software Auto Installer user interface will be launched providing the ability
to auto install the software downloaded from support s ite.
8. It is recommended that you install all the software in th e listed orde r. You can
Select All, to install the software in the order listed.
9. Click the Install button to start the installation.
10. A fter installing all the selected drivers, the Installation Results window is displayed . Click OK.
11. “You m us t restart the system for the settings to take effec t. Do you wish to
reboot now?” message appears. Select Yes.
12. The system will now reboot.
Fujitsu 95