Heat Pump, Split System, Single Service, 3 phase
Maintenance Document 1394-1 111
Cooling Circuit
Line no. Programming line
8756 Flow temperature cooling 1
The actual values of the cooling mode are displayed. The cooling mode room setpoint is displayed on
programming line 8741.
Domestic Hot Water
Line no. Programming line
8820 DHW pump
8821 Electric immersion heater DHW
8830 DHW temp 1
8840 Hours run DHW pump
8841 Start counter DHW pump
8842 Hours run el DHW
8843 Start counter el DHW
The measured values, the DHW circulation pump and
charging temperature, operating hour and startup
counters are displayed, as well as temperatures of
the primary controllers and DHW heater.
Swimming Pool
Line no. Programming line
8900 Swimming pool temp
The current temperature of the swimming pool is
displayed.
Line
Line no. Programming line
8950 Common flow temp
Multifunction Relay Status
Line no. Programming line
9031 Relay output QX1
9032 Relay output QX2
9033 Relay output QX3
9034 Relay output QX4
9035 Relay output QX5
9036 Relay output QX6
9037 Relay output QX7
The switching status of multifunction relays 1 - 6 can
be viewed individually on these lines. The display
"Off" means that the components assigned to this
output are currently disconnected. The display "On"
means that the associated components are currently
switched on.
To Next Page
Loading...
