FUNAI 32FL552/10 - Channel Management; Manual Tuning Procedures; Programme Editing and Management

11
EN
[ATV Manual Tuning]
For Analogue TV operation
You can search ATV channel manually in your area.
2 Use ▲ / ▼ to select [ATV Manual Tuning], then
press OK.
3 Use the Number buttons to enter the 4-digit PIN
code you set.
4 Use ▲ / ▼ to select [Current CH], then use ◄ /
► to select the channel you want.
5 Use ▲ / ▼ to select [Sound System], then use
◄ / ► to select the system you want.
6 Use ▲ / ▼ to select [Fine-Tune], then use ◄ / ►
to adjust the setting.
7 Use ▲ / ▼ to select [AFC], then use ◄ / ► to
select [On] or [Off].
8 Use ▲ / ▼ to select [Search], then press OK to
start scanning.
[DTV Manual Tuning]
For Digital TV operation
You can search DTV channel manually in your area.
2 Use ▲ / ▼ to select [DTV Manual Tuning], then
press OK.
3 Use the Number buttons to enter the 4-digit PIN
code you set.
4 Use ◄ / ► to select the channel you want, then
press OK to start scanning.
[Programme Edit]
For Digital TV operation
You can edit the programme settings.
2 Use ▲ / ▼ to select [Programme Edit], then
press OK to show programme edit list.
Delete channels : [Delete]
3 Use ▲ / ▼ to select the channel you want, then
press RED to delete the current channel.
Setting unshown channels : [Skip]
3 Use ▲ / ▼ to select the channel you want, then
press BLUE to set the current channel as
unshown channel.
Setting favourite channels : [Fav]
Using Favourite function, refer to “Favourite” (p. 5).
3 Use ▲ / ▼ to select the channel you want, then
press FAV to set the current channel as favourite.
Switching channel number : [Move]
You can switch the current programme with the other
channel number.
3 Use ▲ / ▼ to select the channel you want, then
press YELLOW, and use the Number buttons
to enter the other channel number you want to
set, then press OK.
New channel number : [Move]
You can place the current programme to new channel
number.
3 Use ▲ / ▼ to select the channel you want, then
press YELLOW, and use the Number buttons
to enter the unused channel number you want to
set, then press OK.
• If you set to [On], this unit adjust tuning to near channel
automatically.
• You can check favourite channel list at “Favourite” (p. 5).