FUNAI 32FL552/10 - Time and Timer Settings; Clock and Time Zone Configuration; Sleep and OSD Timer Settings

15
EN
Time Settings
You can change Time setting.
1 Use ◄ / ► to select [TIME].
[Time Zone]
You can set the time zone according to the resident
area.
2 Use ▲ / ▼ to select [Time Zone], then press OK.
3 Use ▲ / ▼ / ◄ / ► to select the time you want,
then press OK.
[Sleep Timer]
The sleep timer can be set the unit to go to the standby
mode after an incremental period of time.
2 Use ▲ / ▼ to select [Sleep Timer], then press
OK.
3 Use ▲ / ▼ to select the time you want, then
press OK.
[Auto Standby]
You can set the time to go into standby mode
automatically as no activity is detected after power is
turned on.
In spite of this setting, the unit goes into standby mode
automatically if there is no signal input from the
antenna terminal and no user operation for 15 minutes.
2 Use ▲ / ▼ to select [Auto Standby], then press
OK.
3 Use ▲ / ▼ to select the time you want, then
press OK.
[OSD Timer]
You can set the OSD displaying time during no activity
is detected after press MENU.
2 Use ▲ / ▼ to select [OSD Timer], then press
OK.
3 Use ▲ / ▼ to select the time you want, then
press OK.
• [Clock] will change with the area which you have selected
in the Time Zone.
• Although you select [Auto], the correct time may not be
displayed on the “Sleep Timer” (p. 6) depending on DTV
broadcasting.
• You can set also buttons on Remote Control, refer to “Sleep
Timer” (p. 6).
Clock
Time Zone
Sleep Timer
Auto Standby
OSD Timer
Jul
GMT+1
Off
4 H
15 S
TIME
Move SelectReturn Exit