FUNAI 32FL552/10 - Initial Setup Process; First Time Installation Guide; Location and Tuning Configuration

4
EN
INITIAL SETUP
This section will guide you through the unit's initial
setup which includes selecting a language for your on-
screen menu and auto scan, which automatically
scans and memorises viewable channels.
1 After making all the necessary connections, turns
on the unit using the main power switch, then
press .
2 Use ◄ / ► to select the location.
3
Use ▲ / ▼ to select [OSD Language] , the n select
the language you want, using ◄ / ►.
4 Use ▲ / ▼ to select [Auto Tuning], then press
OK.
5 Use ▲ / ▼ to select [Country], then select the
country you want, using ◄ / ►.
6 Use ▲ / ▼ to select [Tune Type], then select
[DTV], [ATV] or both channels, using ◄ / ►.
< For DVB-T scanning >
7 Press OK to start scanning.
< For DVB-C scanning >
7 Use ▲ / ▼ to select [Digital Type], then select
[DVB-C], using ◄ / ►.
8 Use ▲ / ▼ to select [Scan Type], then select
[Standard] or [Advanced], using ◄ / ►.
9 Use ▲ / ▼ to select the item you want, and then
adjust the setting, using ◄ / ►.
10 Press OK to start scanning.
• Select [Home Mode], this unit is set to maximise the energy
efficiency for home setting and it can be adjusted through a
choice of picture and sound quality according to your
preference.
• Select [Retail Mode], this unit will be set up with predefined
setting for retail displays.
• If you select [Retail Mode], the confirm message will
appear.
OK
First Time Installation
Home Mode
English
OSD Language
Auto Tuning
Standard
Auto Tuning
OK Menu
Auto
Symbol Rate
Auto
Frequency
Auto
Network ID
Scan Type
ATV + DTV
Tune Type
Germany
Country
DVB-T
Digital Type
• Scan confirmation menu will appear.
• In case when not all available cable channels are found
through [Standard] scanning mode, these programs can be
scanned by selecting [Advanced] mode. Please note, that
[Advanced] mode scanning can take additional time.
• Depending on cable TV provider specification, correct
subscription to cable signals cannot be guaranteed.
• When the scanning is completed, the lowest memorised
digital or analogue channel will be displayed.
• If you press MENU during channel scanning, this operation
will be paused, then press MENU again to exit the initial
setup.
Standard
Auto Tuning
OK Menu
Auto
Symbol Rate
Auto
Frequency
Auto
Network ID
Scan Type
ATV + DTV
Tune Type
Germany
Country
DVB-C
Digital Type