4.4
Initialize Setting
Initialize Setting Initialize Setting
Initialize Setting
4-36
Open “INITIALIZE -> 7: NETWORK” menu. You can find “2 [NETWORK SETTIG]”
menu added to the “NETWORK” menu.
6. When you open the “2 [NETWORK SETTIG]” menu, the “1 [RADAR]”, “2
[CARD 1]” and “3 [CARD 2]” menus are displayed.
7. Select “1 [RADAR]” and set the data of the IP address and Subnet mask.
8. When the setting is complete, select “YES” in “6 WRITE SETTING” and click the
left button. When “YES” is selected, the YES. is shown in the box.
9. When the message “Completed!! Power on restart.” Is displayed, restart the power.
10. Call up the “INITIALIZE” menu again and make sure that the address has been
changed in “8 NETWORK”.
How to Reset the Radar IP address to the Default
1. Press the [Menu] key 5 times while holding down the [1] key to call up the
“INITIALIZE” menu.
2. Select “INITIALIZE -> 4: INSTALLATION -> 4: RADAR NO” and click the left
button.
3. When the message “Completed!! Power on restart.” is displayed, restart the power.
4. Call up the “INITIALIZE” menu again and make sure that the IP address has been
reset to the default in “8 NETWORK”.
To Next Page
Loading...
