Furuno FAR-2807 Series - Table of Contents

1
Introduction ..................................................................................... 1
1. Calling up an operational menu...................................................................................1
2. Do not turn off the power immediately after changing the setting..............................1
3. Changing of IP address................................................................................................1
4. Display of HDG, SPD and POSN................................................................................1
5. Notes for setting .........................................................................................................1
6. Checking on NMEA data interface..............................................................................2
7. Loop Back test.............................................................................................................2
8. ERROR/ALM..............................................................................................................2
9. Program updating ........................................................................................................2
10. Connection of sub monitor........................................................................................2
11. LAN connection.........................................................................................................3
12. Connection with ECDIS ............................................................................................4
13. Compatibility of RPU-013.........................................................................................4
Chapter 1. Configuration ........................................................................ 1-1
1.1 Overview .................................................................................................................1-1
1.1.1 Samples ..........................................................................................................1-2
1. FAR-2127 and FAR-2827 ...........................................................................1-2
2. FAR-2137S and 2837S ...............................................................................1-2
3. FAR-2827W ................................................................................................1-3
4. FAR-2837SW .............................................................................................1-3
1.1.2 Inter-switch ....................................................................................................1-4
1.2 Configuration ...........................................................................................................1-5
1.2.1 System configuration table ............................................................................1-5
1.2.2 Processor unit: RPU-013 ...............................................................................1-8
1.2.3 Cable ..............................................................................................................1-9
1. Cable length for each unit ...........................................................................1-9
2. LAN cable ...................................................................................................1-9
3. Extending cables between Antenna unit and Processor unit ......................1-10
1.2.4 Antenna unit ..................................................................................................1-11
1. Applicable model: FAR-2117, 2127, 2817, 2827, 2117-BB and 2127-BB 1-11
2. Applicable model: FAR-2827W .................................................................1-12
3. Applicable model: FAR-2137S, 2837S and 2137S-BB ..............................1-13
4. Applicable model: FAR-2837SW ...............................................................1-15
1.3 Specifications ...........................................................................................................1-16
1.3.1 TR unit and Antenna Radiator .......................................................................1-16
1.3.2 Monitor unit ...................................................................................................1-18
1.3.3 Current power consumption ..........................................................................1-19
1.4 List of Functions ......................................................................................................1-20
Content
s