7.5 Monitor Unit
7-73
7.5 Monitor Unit
7.5.1 Overview
See page.4-41 for the selecting and setting of a monitor unit to be connected.
See page.7-76 for connection with a monitor unit not given below.
- MU-201CR
This is an LCD of SGXA type. SXTA signals are inputted from RPU-013 by the
setting of S1-1/2 (OFF/OFF) of the SPU board.
- MU-231CR
This is an LCD of UXGA type. SXGA signals having a little larger width are
inputted from RPU-013 by the setting of S1-1/2 (ON/OFF) of the SPU board.
However, since these signals do not fit the LCD size, they are converted on the
DVI I/F board of MU-231CR so as to fit the LCD size.
Table 7.5.1 LCD monitor unit
MU-201CR
(20. inches)
MU-231CR
(23.1 inches)
Remarks
Output signal
from RPU-013
1024 x 1280 dots 1024 x 1360 dots
The number of output dots
differs according to the
setting of S1 of the SPU
board.
Monitor display
process dots
1024 x 1280 dots 1200 x 1600 dots
Dots in radar
effective radius
496 dots 496 dots
Radar effective
radius
308 mm 340 mm
SPU board
S1-#1/2
OFF/OFF ON/OFF
To Next Page
Loading...
