Furuno FAR-2807 Series - Page 431

Q & A
8-11
46. How to erase the MARK
The MARK can be erased in [Menu] -> 5 -> 8:DATA ERASE.
To erase an entered mark individually, select “MARK DELETE” in the
[CURSOR] icon menu and place the cursor on the mark to be erased and click the
left button
47. How to display echoes in color
See page.3-17 and 4-25.
Echoes cannot be displayed in color on the IMO and A types.
To display echoes in color, select “COLOR” in “1. ECHO COLOR” of the
[BRILL] box menu.
48. How to create the NAV line
See Chapter 5 of the Operator’s Manual.
1) Register WPT in [Menu] -> 8 -> 6:WPT SET.
The registered WPT can be checked in [Menu] -> 8 -> 7:WPT LIST.
2) Register NAV LINE in [Menu] -> 8 -> 8:NAV LINE SET.
The registered NAV LINE can be checked in [Menu] -> 8 -> 9:NAV LINE
LIST.
3) Check to see that INTERNAL DATA is set in [Menu] -> 8 -> 2:NAV LINE
DATA.
4) Type the NAV LINE number registered in [Menu] -> 8 -> 3:NAV LINE
SELECT.
5) Make the setting of the NAV LINE WIDTH in [Menu] -> 8 -> 4:NAV
ARRIVAL WPT ALARM, [Menu] -> 8 -> 5:NAV LINE WIDTH.
Note:
To make the setting of NAV LINE from the external GPS,
1) Output WPL and RTE sentences from the GPS.
2) Select EXT DATA in [Menu] -> 8 -> 2:NAV LINE DATA.
49. The NAV LINE from GPS cannot be displayed.
Check the following items.
- Is the GPS outputting WPL and RTE sentences?
- RTE sentence must be “w” working route data.
- Number of main point included in RTE sentence is 30 or less.
- Is “EXT DATA” selected in the setting of [Menu] -> 8 -> 2:NAV LINE DATA
on the FAR side?