10-7
TD SETUP menu description
This menu selects the Loran C or Decca chain
to use to display position in TDs. To display it,
press the [MENU] key followed by the
GPS/DPGS/TD OPTIONS and TD SETUP soft
keys.
TD
SETUP
GPS 3D
RETURN
LORAN C
GRI 9940 11-27
U.S. WEST COAST
CORRECTION1 +000.0µs
CORRECTION2 +000.0µs
DECCA
DEC CHAIN 20 R-P
FRENCH
CORRECTION1 +00.00 lane
CORRECTION2 +00.00 lane
EDIT
▼
TD setup menu
Displaying LORAN C TDs
1. Select GRI and press the EDIT soft key to
show the GRI & sta. pair window.
GRI & STA. PAIR
▲
9940 11-27
▼
U.S. WEST COAST
▼
GRI & sta. pair window
2. Press ▲ or ▼ to select GRI code. Press !
to enable selection of station pair, and then
press ▲ or ▼ to select station pair. See the
Loran C chain list at the end of this manual
for GRI and station pairs.
3. Press the ENTER soft key or the [ENTER]
key to register your selection.
4. If necessary, you may enter a position
offset to refine Loran C position. Select
LORAN C CORRECTION1 or
CORRECTION2 and press the EDIT soft
key. Enter correction value and press the
ENTER soft key or the [ENTER] key. Use
the + <--> - soft key to switch from plus to
minus and vice versa.
Displaying DECCA TDs
1. Select DEC CHAIN and press the EDIT
soft key to show the chain sta. pair window.
CHAIN STA. PAIR
▲
20 P-R
▼
FRENCH
▼
Chain sta. pair window
2. Press ▲ or ▼ to select Decca chain
number. Press ! to enable selection of
lane, and then press ▲ or ▼ to select lane
pair (R: red, G: green and P: purple). Refer
to the Decca chain list at the end of this
manual.
3. Press the ENTER soft key or the [ENTER]
key to register your selection.
4. If necessary, you may enter position offset
to refine Decca position. Select DECCA
CORRECTION1 or CORRECTION2 and
press the EDIT soft key. Enter correction
value and press the ENTER soft key or the
[ENTER] key. Use the + <--> - soft key to
switch from plus to minus and vice versa.
10.4 CONFIGURATION menu
The configuration menu has facilities for setting
up data ports, uploading/downloading data,
selftest, demonstration mode setup, and
memory clearing.
1. Press the [MENU] key.
2. Press the CONFIGURATION soft key to
display the configuration menu.
CONFIG
DGPS 3D
SETUP NMEA PORT 1
UPLOAD/DOWNLOAD DATA
SETUP NMEA/DGPS PORT 2
SYSTEM MENU
RETURN
Configuration menu
To Next Page
Loading...
