12-1
12. MAINTENANCE &
TROUBLESHOOTING
12.1 Maintenance
Regular maintenance is essential for good
performance. A maintenance program should
be established and should at least include the
items listed in Table 12-1.
Note: The equipment may restart when certain
metallic parts on the rear of the display
unit are touched. This is caused by
static electricity. No operational error
occurs.
Do not open the equipment.
Hazardous voltage which can
cause electrical shock, burn or
serious injury exists inside the
equipment. Only qualified
personnel should work inside
the equipment.
WARNING
Table 12-1 Recommended maintenance program
Item Check point Remedy
Antenna Check for loosened and corroded bolts.
Tighten loosened bolts. Replace
heavily corroded bolts.
Check connection point for
watertightness.
Check connector for tightness and
corrosion.
Antenna cable
Check cables for damage.
Replace damaged parts.
Display unit
connectors
Check for tight connection and
corrosion.
Tighten loosened connectors.
Ground terminal
Check for tight connection and
corrosion.
Clean or replace as necessary.
Display unit
Dust and foreign material on the display
unit and screen.
Dust or dirt on the display unit can be
removed with a soft cloth. If desired, a
water-moistened cloth may be used.
Do not use chemical cleaners to clean
the display unit - they can remove
paint and markings. Use special care
when cleaning the LCD since it
scratches easily.
To Next Page
Loading...
