11-1
11. USING C-MAP NT MODEL
The GP-1640 C-MAP NT series uses
FURUNO mini chart card and C-MAP NT-FP
chart card. These charts show accurate
coastlines, depth contours, place names, aids
to navigation such as buoys and lighthouses,
and other navigational marks.
11.1 Inserting Chart Card
Insert an appropriate chart card before turning
on the power.
1. Push down the lid catch to open the chart
card slot cover.
Card slot
Location of chart card slot cover
2. Insert appropriate chart card groove side
up.
3. Close the slot cover to protect the chart
drive. (Keep the slot cover closed at all
times.)
Note1: Turn off the power before inserting or
ejecting the chart card.
Note2: When using C-MAP NT-FP card, do
not eject it while a chart is being drawn.
This may cause the equipment to stop
working.
11.2 Cursor and Data Display
Besides its fundamental functions of providing
position data, the cursor can also show caution
area, depth area, source of data, etc. Further,
you can display information about an icon by
placing the cursor on it.
1. Press the cursor pad to turn the cursor on.
DGPS 3D
CENTER
GO TO
CURSOR
COURSE
UP
ZOOM
OUT
ZOOM
IN
NORTH
UP
135° 12.345' E
34° 12.345' N
OS
FROM
276.9°
16.45nm
Plotter display
2. Use the cursor pad to place the cursor on
the position desired.
3. Press the [ENTER] key to open the Objects
window. For example the following window
appears.
Objects
Depth area
Source of data
Caution area
Objects window
To Next Page
Loading...
