10-9
ANT
XDR
DGPS
NMEA
13GND
2
12-24
VDC
-
+
Connect PC to DGPS.
Display unit, rear view
Set communication software on the PC as
follows:
Baud Rate: 4800 bps
Character Length: 8 bit
Stop bit: 1 bit
Parity: None
X Control: XON/XOFF
The following data can be
downloaded/uploaded between a personal
computer and this equipment.
• Waypoint data (In alphanumeric order)
• Route data (In order of route number)
• End of sentence
Note 1: There are two kinds of data for route
data: route data and route comment
data.
Note 2: DGPS position fix is not available when
uploading or downloading data.
Download waypoint/route to PC
1. Connect the PC to the equipment as shown
on the next page.
2. Press the DOWNLOAD WPT/RTE TO PC
soft key. You are asked if you are ready to
download waypoints and routes.
3. Press the [ENTER] key to download.
Upload waypoint/route from PC
Note that all waypoint and route data stored in
your unit will be deleted when data is
uploaded.
1. Connect the PC to the equipment as shown
on next page.
2. Press the UPLOAD WPT/RTE FROM PC
soft key. You are asked if you are ready to
upload waypoints and routes.
3. Press the [ENTER] key to upload.
To Next Page
Loading...
