Note: In case of multiple MFDs, connect the MFD set as “Master” directly to the PSU.
(Please refer to the paragraph “Which MFD should be set as ” p.45 for more
information)
Ethernet Cables that can be used to extend the Ethernet Radar Connection:
- 2 Meter RJ45 to RJ45 Ethernet Cable (P/N 000-167-175)
- 5 Meter RJ45 to RJ45 Ethernet Cable (P/N 000-167-176)
- 10 Meter RJ45 to RJ45 Ethernet Cable (P/N 000-167-177)
Please refer to the DRS Installation Guide for more information on connections inside
the antenna
2.5.1. Connecting the DRS to MFDBB
The MFDBB has an integrated HUB that allows simultaneous connection of the DRS
Ethernet cable and other Ethernet devices (HUB101 for example).
Note: Ethernet Ports 1 and 2 are dedicated for connection of the MCU001 Keyboard.
Connect the DRS Ethernet Cable to Ethernet Port 3. Ethernet Port 4 will be available to
connect the HUB 101 or other Ethernet sensor
To Next Page
Loading...
