Furuno MFD8 - Sounder Configuration

60
3.4.6. Sounder Configuration
Up to 2 Network Sounders can be connected on the NavNet3D network.
NavNet3D is compatible with the DFF1, DFF3, FCV1150 (limited operation), ETR 30
(BBFF1) and ETR60 (BBFF3).
DFF1 and DFF3
Select the DFF1 or DFF3 tab and select the Sounder Source:
a) Transducer Setup:
If you have a TD-ID transducer, “TD-ID” will appear in the pull down menu and
the settings (power and frequency) will be automatically adjusted.
If you don’t have a TD-ID transducer, you can choose between “Model Number”
(for Furuno Transducer only) and Manual (to manually set up the power and
frequency).
b) Transducer Position:
For future use.