Furuno MFD8 - Non Waterproof Connection

43
2.10.2. Non Waterproof connection
When you do not need waterproofing, use the cable fixing plate (supplied in standard
installation materials).
1. Unfasten the four screws to detach the connector cover at the rear of the display
unit.
2. Attach the cable fixing plate by using the binding screw (M3x10, supplied as the
installation materials).
3. Attach each connector to the appropriate location at the rear of the display unit.
4. Wind the cable tie (supplied as the installation materials) to fix the cables to the
cable fixing plate.