When an Engine(s) with a NMEA2000 Port is connected to an MFD in the network, the
Maximum Value of the RPM, Oil and Boost pressure needs to be set up in order to
correctly adjust the scale of the Analog Engine Gauges.
Note: Currently accepted engine data is as follows:
- Engine Parameters (PGN 127488)
Engine Speed
Engine Boost Pressure
- Engine Parameters (PGN 127489)
Engine Oil Pressure
Engine Temp
Engine Temperature Status
Engine Warning Status
Fuel Flow
3.4.2. Assigning Nicknames
You can assign Nicknames to every Ethernet Sensor, NMEA2000 instrument and
NMEA0183 Receive Port for every MFD in a network. This will help you remember
locations and assign the sensors designated as the Primary System Data Source during
the next step.
In order to enter new names, the use of a USB keyboard is required. After assigning
To Next Page
Loading...
