6.2. Master Reset
6.2.1. MFDBB
A USB keyboard is needed to perform a Master Reset on the MFDBB
Note: The USB Keyboard needs to repeat the key command when the corresponding
key is held. Some keyboards (such as wireless keyboard) will not be able to reset the
MFDBB
1) Disconnect any network device (only connect one MCU001 Keyboard controller)
2) If the MFDBB is on, Power it OFF by pressing the “Power” key of the MCU001
keyboard for more than 5 sec.
3) Make sure the USB keyboard is correctly plugged into one of the USB ports of
the MFDBB
4) Turn ON the MDDBB. As soon as the last screen of the following sequence
appears (NavNet3D logo on a blue and white cloud background), push and hold
the ESC key until the MFDBB restarts automatically.
To Next Page
Loading...
