Furuno MFD8 - Page 59

59
Name
Description
Example
Position &
SOG/COG
Choose the position-fixing
sensor to use.
GP-320B, GP-330, SC30, Generic NMEA2000 GPS
Heading
Choose the heading sensor
to use
SC-30, SC-50 (@10Hz), PG-500 (@10Hz), Generic
NMEA2000 Heading sensor
Speed Through
Water
Choose the speed (STW)
sensor to use.
Smart sensor (NMEA 0183 or NMEA2000),
Transducer with Speed sensor (DFF1/DFF3)
Water Depth
Choose the depth sensor to
use.
Smart sensor (NMEA 0183 or NMEA2000), DFF1,
DFF3
Water
Temperature
Choose the temperature
sensor to use.
Smart sensor (NMEA 0183 or NMEA2000),
Transducer with Temp sensor (DFF1/DFF3)
Wind
Choose the wind sensor to
use.
FI-501/502, PB-150, WS-200, Generic NMEA2000
wind sensor
Date & Time
Choose the date and time
source to use.
GP-320B, GP-330, SC30, Generic NMEA2000 GPS
Roll and Pitch
Choose the motion sensor
to use.
SC-30, SC-50, SC110
AIS
Choose the AIS equipment
to use
FA-150, FA-30, FA-50, Generic NMEA0183 AIS
Note: If a NMEA0183 Instruments does not appear as a selection in the list, make sure
that the Input Type was correctly connected and assigned at each MFD (in the “Own”
configuration). Please refer to the “NMEA0183” paragraph p.51.
Note: Generic NMEA2000 instrument will appear as a selection for any type of data.
Select the correct Data Source or leave the default selection if no other instruments are
available.
-If you don’t have any DRS (Radar) and Network sounder click on “Save & Exit” to finish
the installation. If you have a radar or sounder, click on “Next” to continue the
configuration.