When Power Over Ethernet (POE) AXIS IP cameras are installed (example:
AXIS212PTZ) Furuno recommends utilizing a separate POE Ethernet Switch to provide
power and Ethernet data to each AXIS IP Camera with a single cable. Then, utilize a
non-POE port on this switch to link the IP Cameras to a HUB101 in a NN3D Network.
IMPORTANT: Never connect a POE port to the HUB101. Always use one of the NON-
Powered ports to connect the HUB101 to the POE Hub.
The IP cameras need to have a specific assigned IP address (from 172.31.200.003
through 006).
Please refer to the appendix for more information on how to configure the AXIS IP
Camera.
To Next Page
Loading...
