- While the vessel is pointed at the target, turn the RotoKey or drag the Slide Bar
to bisect the target with the displayed line.
- As a final test, steer towards a small buoy and confirm that the buoy shows up
dead ahead on the radar when it is visually dead ahead.
- Perform the Main Bang Adjustment as follows:
The Main bang is the “black hole” which appears at the display center on short ranges.
Select “MBS Adjustment” and rotate the RotoKey to suppress the main bang. After
adjusting, push the RotoKey to validate.
- Push on STBY (to stop the antenna rotation)
- If you have another DRS, choose it from the “Radar Source Select” pull down menu
and repeat the process
FAR21X7
No setup is required in the Installation Wizard for the 21X7 (setup is done from the 21X7
radar processor)
Click on “Exit” (make sure that the Radar is on STBY or the button will not be available).
Important: If you are using an MFDBB, the Keyboard will not work until it is properly
“Linked” to a processor unit. Please refer to the next paragraph “
To Next Page
Loading...
