Note: If you use the same camera models in multiple locations, BE SURE to WRITE
DOWN the IP Camera serial number (that can be found on the back of the camera) with
the intended location to help correctly assign the IP camera’s name.
In this example, we will assign a moving camera (212 PTZ) to IP Camera 1 (Deck), a
non-moving camera with the SN ending with 34CB to IP Camera 2 (Engine Port) and a
non-moving camera with the SN ending with 3441 to IP Camera 3 (Engine Starboard).
To change the IP address of the Camera, just select the camera in the list and click on
the “assign new IP address to selected device” button
Enter the correct IP address and click on “Assign”
You will need to restart (power OFF and ON) the camera after the address is changed.
(Just unplug and plug back the Ethernet cable if you are using the POE).
To Next Page
Loading...
