Furuno TZT16F - Page 48

3. HOW TO SET UP THE EQUIPMENT
3-10
CZone
[Initial Setup] menu - [Engine & Tank Automatic Setup]
The TZT16F will automatically detect engines and tanks connected to the same net-
work.
This is the recommended method for setting up engines and tanks.
[Initial Setup] menu - [Engine & Tank Manual Setup]
The manual set up method should only be used if the automatic setup did not correctly
detect your engines or tanks.
[Manual Fuel Manage-
ment]
Set to [ON] for manual fuel manage-
ment. See the Operator’s Manual.
[OFF], [ON].
Menu item Description
[Add Default CZone
Pages]
Create, edit C-Zone pages.
[CZone DIP Switch
Settings]
Set this unit’s DIP switches. For the serviceman. Do not change the set-
tings.
Menu item Description
[Reset Instrument Pag-
es]
Resets all instrument pages to default. [OK], [Cancel]
[Reset Default Set-
tings]
Resets applicable settings to default. [OK], [Cancel]
Menu Item Description Options (setting range)
[Nickname] Change the nickname for the engine or tank.
[Used For Propulsion] Select which engine/tank is used to
calculate the distance which may be
traveled using the remaining fuel. [ON]
uses the engine/tank for calculations, [OFF]
ignores the engine/tank.
[ON], [OFF]
[Reset] Resets the engine/tank details to default.
Menu item Description Options (setting range)