16
Before Using
Digital Trim Operation
(Initial settings: DT1: Steering trim, DT2: Throttle trim)
Push the lever to the left or right (up or down).
The current position is displayed on the LCD screen for about three seconds when
each digital trim is operated.
Steering trim
position
Throttle trim
position
- Each step is indicated by a tone.
- When the trim exceeds the maximum trim adjustment
range, the tone will change pitch and the lever will not
move any farther.
Trim Operation
With the digital trim feature, trim adjustments have no effect on the maximum servo
travel. This prevents the linkages from binding when adjustments are made.
DT2
DT1
Grip lever operation
(Initial settings: DT3=Steering D/R, DT4=Throttle ATL)
Push the lever to the left or right. The current set value is displayed on the LCD
screen for about three seconds when each lever is operated.
DT3
DT4
- A click sound is made at each step.
- When the maximum position is reached at each side,
the tone of the click changes. Thereafter, the set value
does not change.
ATL position
Steering D/R rate
To Next Page
Loading...
Need help?
General
